picture 3 :-

V3 wireless firmware update:-

to update the wireless master, you must used  Special loader code (SWID 0491) is loaded to slave B/C via jumper method (use tx.bat in extras folder to get this SWID).

how to load the

Put slave in SM reader.
run tx.bat in extars folder and choice
odd parity with key F2.
Select target slave with key F8. Select one of these:
- v3 Slave A (T=0)
- v3 Slave A (T=E)
- v3 Slave B  (SWID 0491) [this also works for slave C]

Press F7.
While response is locked (SM - 0, PX - 0 etc.) short the two pins shown on photo (just hold some wire there, don't solder). Code will start loading.
 

picture:- short the two pins with wire to load the slaves firmware easily

Erase the master firmware:- insert the slave with special loader  (SWID 0491) inside the master to erase the master firmware

load the master firmware :- after erase the master firmware by the slave, Put slave ( with special loader  (SWID 0491 ) in Smart mouse reader

insert the card inside the master

Run term_gui.exe
Select odd parity with key F2.
Settings: odd parity, target v3 master, press key F7.
If response is locked (60 60 60....) then exit term_gui.exe and start it again.
Then re-insert card in master (or power plug) and press F7 again.
Code download always starts on this 2nd attempt.

 load the slave firmware : THE JUMPER METHOD:

There is an easy way to load code to slave A/B/C without using scripts.


Put slave in SM reader.
Run term_gui.exe.
Select odd parity with key F2.
Select target slave with key F8. Select one of these:
- v3 Slave A (T=0)
- v3 Slave A (T=E)
- v3 Slave B [this also works for slave C]
 

( when you choice slave B or A , the SWID must be 04F4  or other new SWID   for the last firmware, if you get ( SWID 0491 ) by term_gui.exe  delete the folder and extract form the zip file ( IMAGE30b.zip )

 
Press F7.
While response is locked (SM - 0, PX - 0 etc.) short the two pins shown on photo (just hold some wire there, don't solder).
Code will start loading.